Greatland outdoors 3 room tent manual manual#

Now lift up the center with someone helping on the other side, and put the feet of the #8 into or near the yellow loops at the center of each side. The #6 goes on top of #7, and insert the #6 into the curved end of the #3 poles which are already in the center pocket, and tie the loose green cords to the silver rings at the short end on each of the #3s. Leave the #7 mostly inserted into the #8 until after the center is lifted up. The side supports for the middle are pole #8 with the white clamp on the bottom, and pole #7 slid into pole #8 (The #7 was scraped off both of mine). Make another #1/#2/#3, and push it through the pocket across the middle of the tent, and connect the last #3 from the other side. Prepare a #4/#5 pole the same as the front, and prop up the back of the tent, putting the feet near the side loops of the floor which are about 1/3 from the rear of the tent. Now prepare the #1/#2 poles for the rear, and attach a #3 to each side and tie the loose green cords to the silver rings on the short ends of the #3s. With help, you should be able to prop up the front of the screen porch, pulling against the stakes holding the rear floor of the tent, and place the rubber feet of the #5 poles close to the center loops of the floor on each side. Do the same thing for the other side of the porch. There should be a rubber foot on the bottom of the #5 pole.

Now insert the small end of pole #4 into the curved end of a #3, then insert the small end of a #5 into the open end of the #4. Later, you will do the exact same assembly with a #3 on each side of a #1/#2 for the poles going across the back of the tent and the poles going through the pocket across the middle/top of the tent.

You should tie the loose green cords on each corner of the screen porch to the silver metal rings at the curved end of each #3. Put the long end of another #3 through the loops starting from the other side and attach to the loose end of the #1/#2. Put the long end of a curved pole #3 through the loops starting from one side, and attach to either side of the 1/#2 you made. Insert one end of a pole #1 into a pole #2 and thread them through the loops over the entrance to the screen porch.

Now assemble the poles going through the loops across the front of the screen porch. Leave the yellow cords attached to the tentloops loose, so you can use the cords to help pull up the stakes when you take down the tent. Start by stretching out the bottom of the tent into a square, and stake all of the perimeter tentloops to the ground, starting with the corners, with the stakes directed at a 30 to 45 degree angle under the tent, so the tent cannot easily pull them back out. I set up the tent by myself, but I recommend 2 people or more, especially if it is windy.

Greatland outdoors 3 room tent manual manual#

I am looking for a manual for Greatland Outdoors 2 room tent with screen porch item #15710, however, I guessed how the poles go together. вЂє Greatland Outdoors 3 Room Tent Manual в… Greatland Camping Tents Instructions Jeep 3 Room Dome Tent 17 X 11